Skip to main content

Site Navigation

Your Account

Choose Language

Changes to this Step

Edit by Micro

Edit approved by Micro

Before
After
Unchanged

Step Lines

[title] Bed Assembly Part 4
[* black] Use about 240mm of wire loom to cover the heater wires. Important: When mounting the Heater Secure the wires with a ziptie to the side tab of the Y Plate. Route the cables down the hole located between the two wheels on the right hand side.
[* icon_caution] Place the Heater and Spreader on the Y Plate with the heater down and the Glass on top. '''Attach the Heater to the Heat Bed port and the Bed Thermistor to T2 on the RAMBo.''' Level the glass by following the next section then secure it using the two front Glass Clips.

Image 1

No previous image

Added