Skip to main content

Site Navigation

Your Account

Choose Language

Changes to this Step

Edit by Micro

Edit approved by Micro

Before
After
Unchanged

Step Lines

[title] Z Assembly Part 2
[* black] You can now attachThe installation of the X needs to be done with the X lowered to the bed height. Attach the X assembly to the Z section. You will use 4 m5-10 screws and nuts for attachment. Loosen the 90 degree brackets on the X and slide to align. The 90 degree brackets mount to the outside edge of the Z plate.
[* black] Install a 90 degree bracket in the front slot of the Z upright 2040's. One of the flat sides of the 90 goes to the 2040 and the other flat side will point up and attach to the Top U Channel Plate of the next step. Finger tighten the mounting screw it will be securely tightened once the Top U channel plate is in place.
[* black] Install the Top U Channel Plate with 4 5m-10 screws. The front of the plate will have 3mm holes and will be shorter, the back has 5mm holes and is taller.
[* black] We will now align the Z 2040s. Remove the screws that connect the Leadscrew Bracket plate to the Z plates (m3-6) on each side. Loosen the two screws on the Top U channel that are located in the slotted holes.
[* black] Move the X assembly all the way to the top position and tighten the screws in the Top U channel plate. Move the X assembly up and down several times to ensure that it moves smoothly in the tracks. Take care to keep it level during this so it does not bind.
[* black] You can now attachThe installation of the X needs to be done with the X lowered to the bed height. Attach the X assembly to the Z section. You will use 4 m5-10 screws and nuts for attachment. Loosen the 90 degree brackets on the X and slide to align. The 90 degree brackets mount to the outside edge of the Z plate.
[* black] Install a 90 degree bracket in the front slot of the Z upright 2040's. One of the flat sides of the 90 goes to the 2040 and the other flat side will point up and attach to the Top U Channel Plate of the next step. Finger tighten the mounting screw it will be securely tightened once the Top U channel plate is in place.
[* black] Install the Top U Channel Plate with 4 5m-10 screws. The front of the plate will have 3mm holes and will be shorter, the back has 5mm holes and is taller.
[* black] We will now align the Z 2040s. Remove the screws that connect the Leadscrew Bracket plate to the Z plates (m3-6) on each side. Loosen the two screws on the Top U channel that are located in the slotted holes.
[* black] Move the X assembly all the way to the top position and tighten the screws in the Top U channel plate. Move the X assembly up and down several times to ensure that it moves smoothly in the tracks. Take care to keep it level during this so it does not bind.