Skip to main content

Site Navigation

Your Account

Choose Language

Changes to this Step

Edit by Roy

Edit approved by Roy

Before
After
Unchanged

Step Lines

[title] Bed Assembly Part 3
[* black] Unpacking the glass bed: The glass is taped to styrofoam to protect it during shipping, cut it free then the tape can best be removed by using heat from a blow dryer or a solvent like rubbing alcohol with a scraping tool. Goo begon has also been used effectively.
[* black] Remove the protective sheet from the Aluminum Heat Spreader. * This film is not on the Heat Spreader if the color is black, red, or blue. Silver only has the protective film.
[* orange] Important: Identifyicon_note] '''Important: '''Identify any bow in the Aluminum Heat Spreader, if one exists the bow should arch up so the glass will help flatten the Spreader. The other side will get the heater. Align and center the Heater on the Spreader and use some tape to attach them for easier assembly.
[* orange] Important: Identifyicon_note] '''Important: '''Identify any bow in the Aluminum Heat Spreader, if one exists the bow should arch up so the glass will help flatten the Spreader. The other side will get the heater. Align and center the Heater on the Spreader and use some tape to attach them for easier assembly.
[* black] Fold the heater back and peel a corner off the backing to expose the adhesive.Slowly apply the Heater to the Spreader, peeling off the backing as you smooth out the heater.