Skip to main content

Site Navigation

Your Account

Choose Language

Changes to this Step

Edit by Micro

Edit approved by Micro

Before
After
Unchanged

Step Lines

[title] Extruder Assembly Part 3
[* black] For those doing a MM2 to MM3 upgrade use the picture in this section as a guide for the extruder conversion.
[* black] The plate that receives the hotend that is 90 degrees from the motor mounting plate gets a screw and a nut on the far left hand side hole. This screw is the bottom retainer for the spring.
[* black] The lever arm, hob, bearing all build just like the mm2 did.
[* black] The hotend is secured with the lower filament guide printed part along with the metal piece shaped similar as the lower guide. Use M3 screw and nut to secure the hotend to the plate.

Image 2

No previous image

Added