Skip to main content

Site Navigation

Your Account

Choose Language

Changes to this Step

Edit by Micro

Edit approved by Micro

Before
After
Unchanged

Step Lines

[title] Z Axis Assembly Part 2
[* black] Install the stepper motors for the Z in the mounts you installed in frame assembly step. Keep the 4 m3-6 button head screws loose until a later step where we adjust the motor.
[* black] Check your leadscrews to make sure there are no defects like seen inInstall the detail highlighted inhelical couplers on the picture for this section. If you find a defect you can use a small file to remove the burrZ stepper motor shafts.
[* black] Check your leadscrews to make sure there are no defects like seen inInstall the detail highlighted inhelical couplers on the picture for this section. If you find a defect you can use a small file to remove the burrZ stepper motor shafts.

Image 1

Old Version

New Version

Image 2

Deleted