Skip to main content

Site Navigation

Your Account

Choose Language

Changes to this Step

Edit by Micro

Edit approved by Micro

Before
After
Unchanged

Step Lines

[* black] Insert wisdom hereInstall the X endstop as shown. The micro switch mounts behind the printed plastic mount with two provided m2 screws. The endstop mounts to the lower left side of the X extrusion. bottom slot.
[* black] Connect all endstops with the cables shown. These cable are packaged with the Rambo controller. You will use the two outside post on the micro switches.
[* black] The Endstop cables will connect to the area highlighted in the picture. The lettering for each port is small but on the board. Install the cables to the X, Y, Z min connectors.
[* black] The board has a MAX xyz input as well and is not used with our printer
.
[* black] Insert wisdom hereInstall the X endstop as shown. The micro switch mounts behind the printed plastic mount with two provided m2 screws. The endstop mounts to the lower left side of the X extrusion. bottom slot.
[* black] Connect all endstops with the cables shown. These cable are packaged with the Rambo controller. You will use the two outside post on the micro switches.
[* black] The Endstop cables will connect to the area highlighted in the picture. The lettering for each port is small but on the board. Install the cables to the X, Y, Z min connectors.
[* black] The board has a MAX xyz input as well and is not used with our printer
.

Image 2

No previous image

Added

Image 3

No previous image

Added