Skip to main content

Site Navigation

Your Account

Choose Language

Changes to this Step

Edit by Micro

Edit approved by Micro


Step Lines

[title] Hatch Cover
[* black] The hatch cover consists of 4 plastic pieces and the metal cover. Two of the plastic pieces mount below the deck plate and can be seen in the hole for the hatch. One of the plastic pieces mounts to the hatch cover, and the final printed piece mounts to the cover in the cutout area to the front. All pieces mount with m3 screws.
[* black] The cover installs with the rear plastic piece of the cover aligning between the two tabs of the plastic piece installed to the rear of the opening of the cover. Once this is aligned you press the front of the hatch down to lock it in place.
[* black] If the fit is to snug you can loosen the screw that holds the printed piece and the retighten with the printed piece pushed a bit further back.

Image 1

No previous image


Image 2

No previous image