Skip to main content

Site Navigation

Your Account

Choose Language

Changes to this Step

Edit by Micro

Edit approved by Micro


Step Lines

[title] Z Axis Assembly
[* black] To begin the Z assembly install the 2040 extrusions to the lower side plate as well as the two short 2020 extrusions. At the top of these two extrusions you will mount the upper side plate as pictured.
[* black] Next assemble the Z plates (X2) as shown. The leadscrew nut will mount to the leadnut bracket with m3-x screws and nuts. This will in turn mount to the Z plate with two m3-6 button head screws.
[* black] Install the wheels into the Z plate. Use the eccentrics and special spacers for the two larger mounting holes.
[* black] Install all wheels with the nuts for the wheels on the plate side of the assembly. If you mount the nut on the wheel side for this section the nut will catch on the upper side plate.
[* black] Install the two Z plate assemblies onto the 2040 upright Z extrusions. Make sure the square hole in each plate is facing the front of the printer. The metal plate itself goes to the inside of the 2040 extrusion as shown.
[* black] You can now attach the X assembly to the Z section. You will use 4 m5-10 screws and nuts for attachment. Loosen the 90 degree brackets on the X and slide to align. The 90 degree brackets mount to the outside edge of the Z plate.