Skip to main content

Site Navigation

Your Account

Choose Language

Changes to this Step

Edit by Micro

Edit approved by Micro

Before
After
Unchanged

Step Lines

[title] Y Axis Assembly Part 3
[* black] Pictured is a detail for the Y idler bearing. This mounts at the opposite end of the Y motor mount and is the far side return point for the Y belt. Installation is an M5x20mm screw, 605 bearing, washer, 605 bearing, washer, D idler plate, extrusion, T-nut.
[* black] If required add a washer to ensure that the bearing properly tightens down. Washer ID and OD are fairly precise but the thickness is not.
[* black] TheTo properly install the bed topplate and wheels you need to identify which end is the same sideup! The production version of the bed plate wherewill have the side bends facebent sides facing up and the front and back bend facebends facing down.
[* black] Install the wheels to the bed plate. Make sure you have the screw head of the wheel screw on the top of the bed plate. Use the wheels that have the V slot cut into the center of them. The larger holes on the left hand side will require the special eccentric spacer on top of the bed plate. The smaller holes do not use this special spacer.
[* black] TheTo properly install the bed topplate and wheels you need to identify which end is the same sideup! The production version of the bed plate wherewill have the side bends facebent sides facing up and the front and back bend facebends facing down.
[* black] Install the wheels to the bed plate. Make sure you have the screw head of the wheel screw on the top of the bed plate. Use the wheels that have the V slot cut into the center of them. The larger holes on the left hand side will require the special eccentric spacer on top of the bed plate. The smaller holes do not use this special spacer.
[* icon_note] '''When installing the wheels the nut will be next to the wheel.''' Refer to guide here: [guide|6]
[* yellow] Once the wheels are installed slide the bed onto the Y frame. The front of the bed will have screw holes for two glass clips on each front side. The front of the Y frame will be end with the Y motor. Turn the eccentric cam to make sure wheels slide on easy to the rails.
[* black] Install the Y belt offset printed part to the bottom of the bed once the bed has been slid onto the rails. This part runs in the slot in the top deck that goes from front to back. Use m3-x screws and m3 nuts to mount this piece.