Skip to main content

Site Navigation

Your Account

Choose Language

Changes to this Step

Edit by Micro

Edit approved by Micro

Before
After
Unchanged

Step Lines

[title] Y Axis Assembly Part 3
[* black] Pictured is a detail for the Y idler bearing. This mounts at the opposite end of the Y motor mount and is the far side return point for the Y belt. Installation is screw, 605 bearing, washer, 605 bearing, washer, D idler plate, extrusion, T-nut.
[* black] If required add a washer to ensure that the bearing properly tightens down. Washer ID and OD are fairly precise but the thickness is not.
[* black] AssembleInstall the wheels to the bed plate withplate. Use the wheels that have the V slot cut into the center of them. The'''When installing the wheels the nut will be next to the wheel. '''The bed top is the same side of the plate where the side bends face upup and the front and back bend face down.
[* black] Once the wheels are installed slide the bed onto the Y frame. The front of the bed will have screw holes for two glass clips on each front side. The front of the Y frame will be end with the Y motor. Install the Y belt offset printed part to the bottom of the bed
.
[* black] AssembleInstall the wheels to the bed plate withplate. Use the wheels that have the V slot cut into the center of them. The'''When installing the wheels the nut will be next to the wheel. '''The bed top is the same side of the plate where the side bends face upup and the front and back bend face down.
[* black] Once the wheels are installed slide the bed onto the Y frame. The front of the bed will have screw holes for two glass clips on each front side. The front of the Y frame will be end with the Y motor. Install the Y belt offset printed part to the bottom of the bed
.

Image 1

Old Version

New Version

Image 2

No previous image

Added

Image 3

No previous image

Added