Skip to main content

Site Navigation

Your Account

Choose Language

Changes to this Step

Edit by Micro

Edit approved by Micro

Before
After
Unchanged

Step Lines

[title] Y Axis Assembly Part 2
[* black] Insert the Y assembly into frame. Get a small square or you can use the plate for the hatch cover and square up the frame with the Y assembly installed. Once you are square : tighten all 16 top deck screws, tighten 4 extrusion and two stiffener screws on ends. Front stiffener should be 2 washers away from the front plate
[* black] Tighten 8 bottom stiffener screws tighten 8 right screws with rail flush to extrusion. Tighten 8 left screws with rail 2 washers thickness away(1.5mm), no more
[* black] You will now remove the Y assembly by removing the 6 screws holding it in place. When the Y assembly is reinstalled later the Y assembly will bring the lower frame back into square. Slide 3 T-nuts inside left extrusion, 2 for y motor, 1 for idler mount Y motor plate assembly inside left extrusion.
[* black] Use the stepper motor without the black sleeve around the wires for this step. The long lead (black covered wires) are used for the X and the extruder. Short cables are used for the Y and the 2 Z motors.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added