Skip to main content

Site Navigation

Your Account

Choose Language

Changes to this Step

Edit by Micro

Edit approved by Micro

Before
After
Unchanged

Step Lines

[title] X Axis Assembly
[* black] With the tapped end of the 2060 extrusion to the right place 2 T-nuts in outside slots on the front. Loosely tighten the 90 Degree Brackets to them, approximately 30mm from the edge of the extrusion.
[* black] With the tapped end of the 2060 extrusion to the right place 2 T-nuts in outside slots on the front. Loosely tighten the 90 Degree Brackets to them, approximately 30mm from the edge of the extrusion.
[* black] Place 1 T-nut in the middle slot about 20mm from the end. Assemble on a m5-25 screw the following. bearing, washer, bearing, washer, bearing, washer and one small D plate with two holes ( 3 bearings, 3 washers).
[* black] Loosely tighten this assembly to the T-nut you installed in the middle slot of the X, either inline (or a bit farther out) with with leftmost 90 Degree Bracket. You might need to add washers if the screw is too long and bottoms out against the extrusion. (D plate shown below. Used in the X and Y belt idler bearing assemblies)
[* black] Place a pulley on the motor, and attach the mounting plate to the motor - mind the wire orientationorientation we want the wire facing down when complete. Place a T-nut in slot 1 and 3 on the rightmost side, and attach the motor plate, with the motor flush with the extrusion end.
[* black] Install 4 wheels withoutwith no the V cut in the center. The nut mounts to wheel side as outlined in the wheel documentation. Slide the X Carriage on to the assembled X Extrusion. '''Note: in picture above the U cut in the carriage plate goes to the bottom with the motor mounted to the right hand side.'''
[* black] Place a pulley on the motor, and attach the mounting plate to the motor - mind the wire orientationorientation we want the wire facing down when complete. Place a T-nut in slot 1 and 3 on the rightmost side, and attach the motor plate, with the motor flush with the extrusion end.
[* black] Install 4 wheels withoutwith no the V cut in the center. The nut mounts to wheel side as outlined in the wheel documentation. Slide the X Carriage on to the assembled X Extrusion. '''Note: in picture above the U cut in the carriage plate goes to the bottom with the motor mounted to the right hand side.'''
[* black] '''The carriage plate shown in the picture is a beta version without a U slot cut into the bottom side of the plate.'''
[* black] The left side of the extrusions is where the tapped holes are to be oriented.