Difficulty
Moderate
Steps
3
Time Required
18:00:00
- Fusematic Build Guide 3 steps
In Progress
This guide is currently being written. Reload periodically to see the latest changes.
Introduction
Thanks for your purchase of the Maker's Tool Works FuseMatic!
We are currently working to update the FuseMatic build documentation to the Dozuki format. If you find a section particularly difficult and have a better way of achieving a build section we ask you to provide comments so we can make the build as easy as possible for all FuseMatic users.
Parts
No parts specified.
-
-
There are a few different types of screws used: SHCS: Socket Head Cap Screw, BHCS: Button Head Cap Screw, FHCS: Flat Head Cap Screw.
-
The T-nuts are installed with the protrusion toward the extrusions
-
-
-
Line 4 T-nuts in middle rail spaced roughly equal with 4 3-hole sets on case.
-
Place 4x M5-8 SHCS into the T-nuts in middle hole with washer in all 4 spots. Tighten all nuts by hand.
-
Align the rail square with edge of case then tighten the M5-8 SHC
-
-
-
Identify the threaded ends of the 450mm extrusions, this is the top.
-
Insert 3 M5 T-nut into a 450mm extrusion, repeat on the other extrusion.
-
Set the Main Case Top over the extrusion aligning the 3 holes with the T-nuts and attach it loosely using 3 M5-8 SHCS with washer.
-
Repeat with the other extrusion on the other side.
-
Square the vertical extrusion. Either using a square or a flat surface. They should be as vertical and parallel as possible, later on the addition of the top frame will help.
-
